When using g_ether and when connected to PC, the PC detects it as RNDIS/Ethernet Gadget and you can assign address, share internet connection to it and so on. The rPi uses dwc2 overlay to control the otg/host functionality and g_ether for the usb interface communication, there are other possibilities as well like g_serial and g_multi. The mini computer (rPi) has only one micro usb interface connected directly to it's cpu which gives the possibility to configure it as usb host/otg.

Once Pi-hole is ready, shut down both RPi and Mikrotik, connect RPi to USB port on Mikrotik, let it boot up.Recently I've tried to connect Raspberry Pi Zero to my RB962UiGS (hap ac).

If you want to change the static assigned IP address AFTER installing Pi-hole, you can edit usb0 interface settings in /etc/nf.

Install Pi-hole - instructions are here, follow the steps and you will end up with Pi with static IP address configured on it.

Configure network access on the PC to allow RPi to reach the Internet - NAT or something.

NOTE - This is required for RPi to show up as LTE interface on Mikrotik!

Options g_ether idVendor=0x05ac idProduct=0x1402 iProduct=Pi0 iManufacturer=Raspberry On the RPi create file called /etc/modprobe.d/g_nf with the following content (single line of text).After all boots up, you should be able to run (thanks mDNS!) with password raspberry.Boot up RPi powering from PC using the port marked as USB on the board - not the PWR IN it's the one in the centre - only that one does power + gadget.cmdline.txt - add modules-load=dwc2,g_ether directly after 'rootwait' and before any other parameters that may (or not) be there.config.txt - at the very end of the file add a line saying dtoverlay=dwc2.Connect SD card to a PC and in partition called boot edit two files to enable Ethernet gadget:.Download and burn the latest Raspbian onto the SD card - I used for this Etcher and -raspbian-buster-lite.img.

Routeros raspberry pi 3